Meru Networks AP1000 Installation Manuals page 50

Installing AP1000e
Figure 37: Assembled Mounting Bracket
Mounting Bar
4. Gently press the underside of the AP1000e against the mounting brace and rotate it into place until
the locking mechanism clicks. Note that this is essentially the same process as depicted in
28.
5. Attach the legs for the mounting kit to the T-Bars in the ceiling by sliding the clips down onto each
respective bar.
6. Remove the top nut from each leg.
7. Lower the crossbar (with the AP attached) onto the legs and screw the nuts back on top of the bar.
8. Connect one end of the PoE Ethernet cable to the Ethernet connector on the AP.
Caution!
mistakenly be plugged into the Console port. If you do this. the AP won't power up.
Note:
Check that the AP1000e is operating correctly before replacing the ceiling tile to the ceiling. Verify
correct operation using the LEDs, as shown in
38 Meru Access Point Installation Guide
Mounting Brace
Clips attach to T-bar
Be sure to connect the Ethernet cable to the Ethernet port; the cable can
Use a shielded Cat 5e (or greater) Ethernet cable in order to comply with
international electromagnetic emissions limits.
Check AP1000e LEDs.
© 2013 Meru Networks, Inc.
Figure