Galvos atramų gale nustatymas
pav. 96 Setting the height of the rear headrest
Aukščio nustatymas
›
Grasp the headrest and move upwards in the direction of
›
To move the restraint down, hold the locking button
arrow
and push the rest in the direction of arrow
2
Removing/inserting the rear headrests
pav. 97 Removing/inserting the rear headrest
›
To remove, pull the rest out of the seat backrest up to the stop.
›
Hold the locking button
A
in the direction of arrow
using a flat screwdriver with a max. width of 5 mm to press the locking but-
ton in the opening
in the direction of arrow
B
direction of arrow
» pav.
97.
3
›
To insert, push the rest into the seat backrest in the direction of arrow
until the locking button clicks into place.
90
Operation
» pav.
96.
1
in the direction of
A
.
3
1
, at the same time
and pull out the rest in the
2
4
Nurodymas
For VarioFlex, the extended headrest can only be removed from the middle
seat only when the safety button
Seat heaters
pav. 98 Buttons for heating the front seats/rear seats
The seat backrests and surfaces of the front seats and the outer rear seats can
be heated electrically.
Sėdynių šildymo mygtukai
» pav. 98
Left seat heating
Right seat heating
›
To turn on the heating to max, press button or .
With repeated pressing of the button, the level is down-regulated until it swit-
ches off . The level of the seat heating is indicated by the number of illumina-
ted warning lights underneath / in the button.
The seat heating only operates when the engine is running.
When the ignition is switched off, the seat heating / ventilation is also swit-
ched off. if the engine is started again within 10 minutes, then the driver's seat
heating / ventilation is switched on again automatically according to the set-
ting before switching off the ignition.
» pav. 97
is held.
A