Table of Contents
Advertisement
pav. 352 Removing the plug / installing the light
Pirmiausiai perskaitykite ir atkreipkite dėmesį į
Removing
›
Open the boot lid.
›
Open the respective cap
or
A
pop-up versions for the right cap
fitted.
›
Remove screw
in the direction of arrow
C
dy, which is fitted with an anti-fall device.
›
Hold the light and carefully remove in the direction of arrow
›
Press the latch
on the holder in the direction of the arrow
D
›
Press the securing lug in the direction of arrow
direction of arrow
.
6
Fitting
›
Slide the plug in the opposite direction of the arrow
light.
›
Secure the latch
in the opposite direction to arrow
D
›
Carefully insert the lamp with the strips
body and the lamp to the stop in the direction of the arrow
›
Tighten screw
in the opposite direction to arrow
C
›
Close the cap
or.
in the opposite direction of arrow
A
B
the respective opening.
ir
puslapyje 296.
in the direction of arrow
» pav.
B
1
are different depending on equipment
B
. The screw remains in the bo-
2
.
3
4
and pull out the plug in the
5
» pav. 352
6
.
4
into the guide grooves
F
7
»
» pav.
351.
2
and insert into
1
ATSARGIAI
Ensure that when re-inserting the light the wiring harness between the body
■
and the light is not jammed and the seal
Otherwise there is a risk of water ingress and damage to the electrical installa-
tion.
Ensure that the vehicle paintwork and the tail lamp are not damaged when
■
removing and installing the tail lamp.
Changing the bulbs in the taillight (turn signal and reversing lights)
pav. 353 Outer part of the lamp/holder with bulbs
Pirmiausiai perskaitykite ir atkreipkite dėmesį į
351. The
›
Unlock the bulb holder at the areas marked with arrows
ve from the light.
›
Remove the faulty bulb from the holder in the direction of the arrow
›
Insert a new bulb into the holder in the opposite direction to arrow
The lamp holder for the indicator is provided with the lettering .
» pav.
352.
The lamp holder for the reversing lamp is provided with the lettering .
›
Insert the bulb holder into the light
ATSARGIAI
into the
Before inserting the bulb holder into the light , check that the connector
■
» pav. 353
is fitted correctly between the light and the bulb holder.
in the
G
Make sure that when refitting the bulb holder into the light, the wiring har-
■
.
ness
is not pinched - otherwise there is a risk of damage to the electrical
B
installation.
» pav. 352
is correctly inserted -
E
ir
puslapyje 296.
» pav. 353
and remo-
»
. The holder must engage securely.
Fuses and light bulbs
1
.
.
1
A
299
Advertisement
Table of Contents
