›
To adjust the height, hold the locking button
sired direction
» fig.
69.
Setting the height of the rear headrests
Fig. 70 Setting the height of the back headrest
›
Grasp the headrest and moveupwards in the direction of arrow
›
To move the headrest down, press the securing button
arrow
and hold it down while pressing the headrest in the direction of ar-
2
row
.
3
Removing/inserting the rear headrests
Fig. 71 Removing/inserting the rear headrests
Before removing/inserting the headrests, fold the corresponding seat backrest
slightly forward
» page
78.
›
To remove the headrest, pull it out of the seat backrest up to the stop.
80
Using the system
and move the rest in the de-
A
» fig.
70.
1
in the direction of
A
›
Hold the locking button
in the direction of arrow
A
ing a flat screwdriver with a max. width of 5 mm to press the locking button
in the opening
in the direction of arrow
B
rection of arrow
» fig.
71.
3
›
To insert the headrest, push the headrest into the seat backrest in the direc-
tion of arrow
until the locking button clicks into place.
4
Seat heaters
Fig. 72 Buttons for heating the front / rear seats
The seat backrests and surfaces of the front seats and the outer rear seats
can be heated electrically.
Buttons for the seat heating
» fig. 72
Left seat heating
Right seat heating
›
To turn on the heating to max, press the key or button.
By repeatedly pressing the button, the heat is turned down until it is com-
pletely switched off. The level of the seat heating is indicated by the number
of illuminated warning lights underneath / in the button.
The seat heating only operates when the engine is running.
When the ignition is switched off, the seat heating / ventilation is also switch-
ed off. if the engine is started again within 10 minutes, then the driver's seat
heating / ventilation is switched on again automatically according to the set-
ting before switching off the ignition.
, at the same time us-
1
and pull out the rest in the di-
2