Table of Contents
Advertisement
Setting the Infotainment hotspot
The Infotainment hotspot is factory set.
The setting can be changed in menu item
prieigos taškas → Viešos. prieig. taško nust..
Saugumo lygis: - prieigos apsaugos tipas (nuolat nustatyta WPA2)
■
Network key - Access password
■
SSID: ... - Prieigos taško pavadinimas
■
Do not send network name (SSID) - Switch the visibility of the hotspot on/off
■
To save the configured parameters, tap the Store function surface.
▶
Connecting an external device to the Infotainment hotspot
›
Switch on the ignition.
›
Switch on WLAN in the external device and search for the infotainment hots-
pot.
›
Select the Infotainment hotspot and enter the required password.
›
Confirm the connection.
Nurodymas
The name of the Infotainment hotspot (SSID) and the access password can be
found in menu item
→ → Wi-Fi → Mobilusis viešosios prieigos taškas → Viešos.
prieig. taško nust..
Connect Infotainment to the hotspot of the external device
The Infotainment system can only be connected to a hotspot with WPA2
access protection.
›
Switch on the ignition.
172
Infotainment
→ → WLAn → Mobilusis viešosios
pav. 204
Main menu of the Infotainment
WLAN
›
If the Infotainment WLAN is not activated, activate it in the menu item
→ WLAN → WLAN → WLAN.
In area
» pav.
204, a list of available or previously connected hotspots is dis-
A
played.
The hotspot list can be updated by tapping the function surface
›
Select the hotspot and enter the password.
If the hotspot is not visible, you can establish the connection to it manually.
›
Tap the function surface Manual settings.
›
Set the required hotspot parameters.
›
Tap the function surface Connect.
Simboliai ir funkciniai paviršiai disponuojamų interneto prieigos taškų sąra-
še
» pav. 204
A
Connected hotspot
Signal strength of the connected hotspot
Delete the hotspot
Hotspot connection recommendations
▶
Only leave the hotspot to be connected switched on, switch off the other
hotspot.
On some hotspots, the connection setup takes longer, wait for the end of
▶
the connection setup.
If the connection is interrupted, search for available hotspots again and re-
▶
peat connection setup.
▶
Delete unused hotspots. This shortens the time required for connection se-
tup.
Nurodymas
It is not possible to connect Infotainment Columbus to the hotspot of the ex-
■
ternal device as long as a SIM card with enabled data services is in the external
module of Infotainment or a phone connected to Infotainment via the Blue-
®
tooth
rSAP profile.
An Infotainment Amundsen connection with external device hotspot is not
■
possible, as long as there is an active connection using the Carstickdevice.
→
.
B
Advertisement
Table of Contents
