Table of Contents
Advertisement
Function
pav. 278 Prietaisų skydelio ekrano rodinys: greičio ribotuvo būklės indi-
kacijų pavyzdžiai
Pirmiausiai perskaitykite ir atkreipkite dėmesį į
Greičio ribotuvo būklės indikacijos
Speed limit is set, control is inactive (in the colour display the digits of
speed limits is shown in grey).
Control active (in the colour display the digits of the speed limits are high-
lighted).
No speed limit set.
System fault - seek assistance from a specialist garage immediately.
Basic requirements for start of control
The Speed Limiter is activated.
The current speed is greater than approx. 30 km/h.
After starting the system, the current speed is set as the speed limit, the war-
ning light
lights up in the instrument cluster.
Exceeding the speed limit during the regulation
If, during the control, it is necessary to exceed the speed limit (e.g. to overta-
ke), the accelerator pedal must be pressed fully.
When exceeding the speed limit (e.g. driving down a hill), an acoustic signal
sounds and the warning light
flashes in the instrument cluster.
The regulation is resumed once the speed has fallen below the set limit.
puslapyje 232.
» pav. 278
Operation description - Variant without CCS
Pirmiausiai perskaitykite ir atkreipkite dėmesį į
Greičio ribotuvo valdymo elementų apžvalga
Activate speed limiters
A
Interrupt control (sprung position)
Disable speed Limiter (delete set limit )
Take control again
/ increase speed limit - press (in increments of
B
a)
1 km/h), hold (in increments of 10 km/h)
Start control/ reduce speed limit - press (in increments of 1 km/h),
C
hold (in increments of 10 km/h)
a)
If no speed limit is set, the current speed is set as the speed limit.
pav. 279
Controls of the speed limiter
(version without CCS)
puslapyje 232.
» pav. 279
233
Assist systems
Advertisement
Table of Contents
