Skoda KAROQ Owner's Manual page 282

›
Jack up the vehicle» puslapis 282
of the ground.
›
Unscrew the wheel bolts and place them on a clean surface (cloth, paper,
etc.).
›
Remove the wheel carefully.
›
Attach the spare wheel and slightly screw on the wheel bolts.
›
Lower the vehicle.
›
Tighten the wheel bolts opposite each other using the wheel wrench („alter-
nating crosswise")» puslapis 282.
›
Replace the wheel trim » puslapis
When fitting a wheel with a unidirectional tyre, ensure that the direction of ro-
tation is correct » puslapis 274.
All bolts must be clean and must turn easily. If the screws are corroded and
difficult to move, then these must be replaced.
DĖMESIO
Undo the wheel bolts just a little (about one turn) while the vehicle is not
■
jacked up. Otherwise, the wheel could come off and fall down – there is a
risk of injury.
Under no circumstances grease or oil the wheel bolts - risk of accident!
■
Subsequent steps
After changing the wheel, the following work must be carried out.
›
Place the replaced wheel in the trough under the flooring of the luggage
compartment and secure with a locking screw (insert the support base for
the luggage floor back into the screw).
›
Stow the vehicle tool kit in the space provided.
›
Check and, if necessary, adjust the tyre pressure on the assembled wheel,
and, for vehicle with tyre pressure monitoring, save the tyre pressure values
in the system » puslapis 251.
›
Have the tightening torque of the wheel bolts checked with a torque wrench
as soon as possible. The prescribed tightening torque is 140 Nm.
Replace the damaged tyre. It is not recommended to repair the tyre.
280
Do-it-yourself
until the wheel that needs changing is clear
281and the caps » puslapis 281.
DĖMESIO
A tightening torque which is too high can damage the bolts and threads
and this can result in permanent deformation of the contact surfaces on
the rim. Too low tightening torque, the wheels may fall off while driving -
risk of an accident. Therefore, drive cautiously and only at a moderate
speed until the tightening torque has been checked.
Removing/stowing the emergency or spare wheel
pav. 317 Take out wheel
The spare wheel is located in a well under the floor covering in the luggage
compartment and is fixed in place with a fastening screw
Take out wheel
›
Lift up the floor in the luggage compartment.
›
Remove the support base for the luggage floor in the direction of the arrow
and the locking screw in the direction of the arrow
1
Store wheel away
›
Place the wheel into the wheel well with the wheel rim pointing downward.
›
Tighten the locking screw in the opposite direction of arrow
» pav. 317.
›
Re-insert the support base in the luggage floor in the opposite direction to
arrow .
1
›
Fold back the floor in the luggage compartment.
» pav. 317.
» pav. 317.
2
until it stops
2