CAUTION
If the tablet holder adapter is secured to the guide rods of the headr-
ests» page 103
, do not push the headrests down to the stop – risk of damag-
ing the headrests.
Adjusting the height of the rear headrests
Fig. 92 Setting the height of the back headrest
›
Grasp the headrest and move upwards in the direction of
›
To move the headrest down, press the securing button
arrow
2
and hold it down while pressing the headrest in the direction of ar-
row
.
3
Removing/inserting the rear headrests
Fig. 93 Removing/inserting the rear headrests
Before removing/inserting the headrests, fold the corresponding seat backrest
slightly forward
» page
88.
90
Operation
›
To remove, pull the rest out of the seat backrest up to the stop.
›
Hold the locking button
ing a flat screwdriver with a max. width of 5 mm to press the locking button
in the opening
rection of arrow
›
To insert the headrest, push the headrest into the seat backrest in the direc-
tion of arrow
Seat heaters
» Fig.
92.
1
Fig. 94 Buttons for heating the front seats/rear seats
in the direction of
A
The seat backrests and surfaces of the front seats and the outer rear seats can
be heated electrically.
Seat heating buttons
Left seat heating
Right seat heating
›
To turn on the heating to max, press the key or button.
With repeated pressing of the button, the level is down-regulated until it
switches off . The level of the seat heating is indicated by the number of illu-
minated warning lights underneath / in the button.
The seat heating only operates when the engine is running.
When the ignition is switched off, the seat heating / ventilation is also switch-
ed off. if the engine is started again within 10 minutes, then the driver's seat
heating / ventilation is switched on again automatically according to the set-
ting before switching off the ignition.
in the direction of arrow
A
in the direction of arrow
and pull out the rest in the di-
B
2
» Fig.
93.
3
until the locking button clicks into place.
4
» Fig. 94
, at the same time us-
1