Table of Contents
Advertisement
Driver of the towed vehicle
›
If possible, the vehicle should be towed with the engine running. Operate the
brake booster and power steering only if the engine is running, otherwise the
brake pedal must be depressed more strongly and more power has to be
directed to the steering.
›
If it is not possible to start the engine, switch on the ignition so that the stee-
ring wheel is not locked and so that the turn signal lights, windscreen wipers
and windscreen washer system can be used.
›
Take the vehicle out of gear or move the selector lever into position N if the
vehicle is fitted with an automatic gearbox.
›
Always keep the tow rope taut during the towing procedure.
DĖMESIO
Wound tow ropes must not be used for towing
■
eye may unscrew out of the vehicle - risk of accident.
Ensure tow rope is not twisted - risk of accident.
■
ATSARGIAI
Do not tow-start the engine – risk of damaging the engine! The battery from
■
another vehicle can be used as a jump-start aid
In the case of off-road towing manoeuvres, for both vehicles there is the risk
■
that the fastening parts could be overloaded and damaged.
Nurodymas
We recommend that you use the tow rope from ŠKODA Original Accessories.
Front towing eye
pav. 327 Remove protective grille / install towing eye
» pav.
326- , the towing
» puslapis
285, Jump-starting.
Removing/inserting protective grille
›
To remove, insert the clamp for taking off the full wheel trims in the recess in
the protective grille and remove the protective grille in the direction of arrow
» pav.
327.
1
›
To insert, insert the protective grille in the opening and push in gently. The
protective grille must engage firmly.
Removing/installing the towing eye
›
To install, screw in the towing eye by hand in the direction of arrow
» pav. 327
until the
stop»
.
›
Tighten the towing eye using a wheel wrench or similar object. To do this, in-
sert the wheel wrench through the eye.
›
To remove, unscrew the towing against the direction of arrow
DĖMESIO
The towing eye must always be tightened, otherwise the towing eye may
break during the towing.
Towing eye rear
pav. 328 Remove cap / install towing eye
Remove/insert cap
›
To remove, press on the cap in the direction of the arrow
in the direction of arrow
» pav.
2
›
To insert, insert the cap in arrow range
edge of the cap. The cap must engage firmly.
Removing/installing the towing eye
›
To install, screw in the towing eye by hand in the direction of arrow
» pav. 328
until the
stop»
.
2
and remove this
1
328.
and then press on the opposite
1
Emergency equipment and self-help
2
.
3
287
Advertisement
Table of Contents
