Skoda KAROQ Owner's Manual page 283

Hide thumbs Also See for KAROQ:
Table of Contents

Advertisement

Removing/stowing wheel in vehicles with sound system
The spare wheel is located in a well under the floor covering in the luggage
compartment and is fixed in place with a fastening screw.
Take out wheel
Lift up the floor in the luggage compartment.
Press the latch
on the holder in the direction of the arrow
A
Press the latch in the direction of arrow
rection of arrow
.
3
Remove the locking screw in the direction of arrow
Remove the bass loudspeaker.
Remove the wheel.
Store wheel away
Place the wheel into the wheel well with the wheel rim pointing downward.
Insert the bass loudspeaker.
Tighten the locking screw in the opposite direction of arrow
» pav.
318.
Insert the connector in the bass loudspeaker.
Secure the latch
in the opposite direction to arrow
A
Fold back the floor in the luggage compartment.
Full wheel trim
Removing the trim
Hang the clamps for removing the full wheel trims at the edge of one of the
ventilation openings in the full wheel trim.
Push the wheel wrench through the clamp, support on the tyre and pull off
the wheel trim.
pav. 318
Take out wheel
» pav.
318.
1
and pull out the holder in the di-
2
.
4
until it stops
4
.
1
Installing the trim
Press the wheel trim onto the wheel rim at the designated valve opening.
Then press the trim into the wheel rim until its entire circumference locks
correctly in place.
The back of the wheel trim supplied by the factory or from the ŠKODA Origi-
nal Accessories shows the position for the anti-theft wheel bolt. When using
the anti-theft wheel bolt, this is to be fitted in this point
DĖMESIO
We recommend that you use hub caps from ŠKODA Original Accessories.
A sufficient air supply may not be able to be guaranteed with other wheel
trims to cool the braking system – Otherwise there is a risk of an accident.
ATSARGIAI
If the wheel trim is set outside the position marked for the anti-theft wheel
bolt, there is a risk of damaging the wheel trim.
Use only manual pressure and do not hit the full wheel trim – otherwise there
is a risk of damaging the trim.
Nurodymas
We recommend that you use hub caps from ŠKODA Original Accessories.
Wheel bolts
To remove the cap, insert the extraction pliers up to the stop on the cap and
pull this in the direction of the arrow
To install, insert the cap up to the stop on the wheel bolt.
»
.
pav. 319
Remove the cap
» pav.
319.
Emergency equipment and self-help
281

Advertisement

Table of Contents
loading

Table of Contents