Table of Contents
Advertisement
P6010 & P8010 Indicators - Setup Mode
This mode is normally selected only after Configuration Mode has been completed, or is
used when a change to the process set up is required. These parameters must be set as
required before attempting to use the indicator in an application.
Entry into the Setup Mode
Setup Mode is entered from Select Mode
Hold down
The :+$# legend is shown for 1 second, followed by the legend for the current mode.
Press
or
Note:
Entry into Setup Mode is security-protected by the Setup Mode lock code. Refer to the
Unlock Code section for more details.
Note:
1
/
Din indicators have an additional Set LED
8
Scrolling through Parameters and Values
Press
to scroll through the parameters. While this key is pressed, and up to 1
second after, the parameter legend is shown, followed by the current parameter value.
Changing Parameter Values
Press
to select the required parameter, then press
required.
Once the displayed value is changed, it is effective is immediately. No confirmation of
the change is required.
Press
to move onto the next parameter.
Hold down
Note:
If there is no key activity for two minutes the instrument returns to the operator mode.
Page 78
1
1
/
-DIN,
/
-DIN &
4
8
and press
to force the controller into the Select Mode.
to navigate to the Setup Mode option, then press
and press
to return to Select Mode.
P6010 & P8010 Model Group
1
/
- DIN Controllers & Indicators - Product Manual
16
. This is on in Setup Mode.
.
or
to set the value as
59305, Issue 5 – March 2005
Advertisement
Table of Contents
