Table of Contents
Advertisement
10 P6010 & P8010 Indicator – Model Group
These Indicators are ideal for most process monitoring applications. Available with a red,
green or Red/Green colour change display, plug-in modules for latching or non-latching
relays, transmitter power output, or PV retransmission. The P6010
1
48mm) and P8010
• Red, Green or Colour Change display
• PV Retransmit option
• Min/max Value hold
• RS485 Modbus and ASCII comms
P6010 & P8010 Indicators - Configuration Mode
This mode is normally used only when the indicator is configured for the first time or when a
major change is made to the instruments characteristics. The Configuration Mode
parameters must be set as required before adjusting parameters in Setup Mode, or
attempting to use the in an application.
Entry into the Configuration Mode
CAUTION:
Adjustments to these parameters should only be performed by personnel
competent and authorised to do so.
Configuration is entered from Select Mode
Hold down
The :+$# legend is shown for 1 second, followed by the legend for the current mode.
Press
or
Note:
Entry into this mode is security-protected by the Configuration Mode Lock Code. Refer to
the Unlock Code section for more details.
Note:
1
/
Din indicators have an additional Set LED
8
Page 70
1
1
/
-DIN,
/
4
8
/
DIN Indicator (96 x 48mm) offer similar functionality in two DIN sizes.
8
and press
to force the controller into the Select Mode.
to navigate to the Configuration Mode option, then press
P6700, P8700& P4700 Model Group
1
-DIN &
/
- DIN Controllers & Indicators - Product Manual
16
• Up to five Process Alarms
• Transmitter PSU option
• Remote Latched Relay reset
• Configuration via PC
. This flashes in Configuration Mode.
1
/
DIN Indicator (48 x
16
.
59305, Issue 5 – March 2005
Advertisement
Table of Contents
