Displays; Led Functions; Keypad; Table 3. Typical Led Functions - WEST P8700 User Manual

1 1 1
/ -DIN, / -DIN & /
4 8 16

Displays

Indicator models have a single line display, which normally shows the process variable value,
and status indicators LED's for mode and alarm indication. Controllers are provided with a
dual line display and LED indicators for mode, automatic tune, alarm and output status. The
upper display shows the process variable value during normal operation, whilst the lower
display shows the setpoint value. See the preceding diagram - Typical front panels.

LED Functions

LED
ON indicates the Setup Mode has been entered
(This LED is labelled SET on indicator models)
FLASHING indicates the manual mode has been entered
(On indicator models this LED is labelled SET and flashes when in
Configuration Mode )
ON indicates that Controller
FLASHING indicates that Controller
FLASHING indicates that an alarm condition is present
FLASHES in unison with Time Proportioning Primary outputs, or
for Current Proportioned outputs, ON indicates primary power is >0%
(On indicators this lights when the stored Max PV value is displayed )
FLASHES in unison with Time Proportioning Secondary outputs, or
for Current Proportioned outputs, ON indicates primary power is >0%
(On indicators this lights when the stored Max PV value is displayed )

Keypad

Each instrument in the range has either three of four switches, which are used to navigate
through the user menus and make adjustment to the parameter values. See the preceding
diagram - Typical front panels
59305, Issue 5 – March 2005
- DIN Controllers & Indicators - Product Manual
Figure 38. Typical front panel and keys

Table 3. Typical LED functions

Function
Self Tune
mode is engaged
Pre-Tune
mode is engaged
Powering Up Page 29