Table of Contents
Advertisement
P6700, P8700 & P4700 Limit Controllers - Operator Mode
This is the mode used during normal operation of the instrument. It can be accessed from
Select Mode, and is the usual mode entered at power-up.
WARNING:
IN NORMAL OPERATION, THE OPERATOR MUST NOT REMOVE THE INSTRUMENT FROM
ITS HOUSING OR HAVE UNRESTRICTED ACCESS TO THE REAR TERMINALS, AS THIS
WOULD PROVIDE POTENTIAL CONTACT WITH HAZARDOUS LIVE PARTS.
CAUTION:
Set all Configuration Mode parameters and Setup Mode parameters as required
before starting normal operations.
Navigating in Operator Mode
Press
to move between displays.
Table 18. P6700, P8700 & P4700 Operator Mode Displays
Upper
Display
Display
PV Value
Limit SP
Limit SP
Value
High Limit
Hold
Low Limit
Hold
Exceed Time
Value
Active Alarm
Status
Limit Setpoint Adjustment
Adjustment of the Limit Setpoint can be only made from Setup Mode.
Page 64
1
1
/
-DIN,
/
4
8
Lower
When Visible
Display strategy is
set to .%56 .
Value
(Initial Screen)
Display strategy is
Blank
set to D<:5 .
(Initial Screen)
$#9+ = )< in
)<)D'
Configuration Mode
$#9+ = +" in
+")D'
Configuration Mode
Always available
#<'
When any alarm is
5+:#'
active.
ALM indicator
will also flash
P6700, P8700& P4700 Model Group
1
-DIN &
/
- DIN Controllers & Indicators - Product Manual
16
Process Variable and Limit Setpoint
values.
Read only
Limit Setpoint value only.
Read only
Highest PV value since this parameter
was last reset.
Lowest PV value since this parameter was
last reset.
Accumulated time of Limit SP exceed
conditions since this parameter was last
reset. Time Format: mm.ss to 99.59, then
mmm.s (10 sec increments)
Shows
Upper display shows which alarm(s) are
active. Inactive alarms are blank
'''2'
Description
))
(
*
when ≥999.9
Alarm 1 Active
Alarm 2 Active
''3'
Annunciator Active
5%'
59305, Issue 5 – March 2005
Advertisement
Table of Contents
