Table of Contents
Advertisement
P6100, P8100 & P4100 Controllers – Extended Operator Mode
Using the PC configuration software, it is possible to extend the Operator Mode displays
available by adding parameters from Setup Mode. When an extended Operator Mode is
configured the additional parameters are available after the standard operator displays.
Navigating in Operator Mode
Press
to move between displays.
When a display value can be adjusted, use
Note:
The operator can freely view the parameters in this mode, but alteration depends on the
settings in the Configuration and Set Up Modes. All parameters in Display strategy 6 are
read only, and can only be adjusted via Setup mode.
Table 13. P6100, P8100 & P4100 Operator Mode Displays
Upper
Display
Display
PV Value
Active SP
PV Value
Actual SP
PV Value
Actual SP
Value
SP Value
SP1 Value
SP2 Value
Local Setpoint
Value
Remote
Setpoint
Page 48
1
1
/
-DIN,
/
4
8
Lower
When Visible
Display strategy 1
and 2.
Value
(Initial Screen)
Display strategy 3
and 6
Value
(Initial Screen)
Display strategy 4.
Blank
(Initial Screen)
Display strategy 5.
Blank
(Initial Screen)
Display strategy 1, 3,
:-'
4, 5 and 6 if Digital
Input is not D<:O in
config mode and
RSP is not fitted
If Digital Input is set
:-2
for dual SP ( D<:O in
or
config mode).
B:-2'
If Digital Input is set
:-3'
for dual SP ( D<:O in
or
config mode).
B:-3'
If Remote Setpoint
+:-
Input is fitted and
B+:-'
Digital Input is not
or
D<:O in config
*+:-'
mode
If Remote Setpoint
9:-'
Input is fitted and
B9:-'
Digital Input is not
P6100, P8100 & P4100 Model Group
1
-DIN &
/
- DIN Controllers & Indicators - Product Manual
16
or
Process Variable and target value of
currently selected Setpoint.
Local SP is adjustable in Strategy 2
Process Variable and actual value of
selected Setpoint (e.g. ramping SP value).
Read only
Shows Process Variable.
Read only
Shows target value of currently selected
Setpoint. Read only
Target value of Setpoint.
Adjustable except in Strategy 6
Target value of Setpoint 1. B:-2 means
SP1 is selected as the active Setpoint.
Adjustable except in Strategy 6
Target value of Setpoint 2. B:-3 means
SP2 is selected as the active Setpoint.
Adjustable except in Strategy 6
Target value of Local Setpoint. B+:-
means the local setpoint is selected as the
active SP (if the digital input has been
overridden, the _ * character is lit instead).
Adjustable except in Strategy 6
Target value of Remote Setpoint. B9:-
means the remote setpoint is selected as
to change its value.
Description
59305, Issue 5 – March 2005
Advertisement
Table of Contents
