Connections And Wiring; Figure 11. Rear Terminals ( 1 / 16 -Din Instruments) - WEST P8700 User Manual

1 1 1
/ -DIN, / -DIN & /
4 8 16

Connections and Wiring

The rear terminal connections for
following diagrams.
In general, all wiring connections are made to the instrument after it is installed. Copper wires
must be used for all connections (except thermocouple signal wires).
WARNING:
TO AVOID ELECTRICAL SHOCK, AC POWER WIRING MUST NOT BE CONNECTED TO THE
SOURCE DISTRIBUTION PANEL UNTIL ALL WIRING PROCEDURES ARE COMPLETED.
WARNING:
CHECK THE INFORMATION LABEL ON THE CASE TO DETERMINE THE CORRECT
VOLTAGE BEFORE CONNECTING TO A LIVE SUPPLY.
Note:
The wiring diagram below shows all possible combinations. The actual connections
required depend upon the features available on the model and the modules and options
fitted.
59305, Issue 5 – March 2005
- DIN Controllers & Indicators - Product Manual
1
/ DIN and
16
Figure 11. Rear terminals (
1 1
/ & / DIN instruments are illustrated in the
4 8
1
/ -DIN Instruments)
16
Connections Page 15