Table of Contents
Advertisement
9 P6700, P8700 & P4700 Limit Controller – Model Group
Limit Controllers protect processes that could become hazardous under fault conditions, by
shutting down the process at a preset level. They are available in three sizes: P6700
Limit Controller (48 x 48mm), P8700
Limit Controller (96 x 96mm).
• High or low trip
• Exceed & relay trip indicators
• RS485 Modbus and ASCII comms
• PV retransmit option
P6700, P8700 & P4700 Limit Controllers - Configuration Mode
This mode is normally used only when the instrument is configured for the first time or when
a major change is made to the controller characteristics. The Configuration Mode parameters
must be set as required before adjusting parameters in Setup Mode, or attempting to use the
instrument in an application.
Entry into the Configuration Mode
CAUTION:
Adjustments to these parameters should only be performed by personnel
competent and authorised to do so.
Configuration is entered from Select Mode
Hold down
then
Press
or
Note:
Entry into this mode is security-protected by the Configuration Mode Lock Code. Refer to
the Unlock Code section for more details.
Scrolling through Parameters and Values
Press
to scroll through the parameters (parameters are described below).
Note:
Only parameters that are applicable to the hardware options chosen will be displayed.
Page 56
1
1
/
-DIN,
/
-DIN &
4
8
1
/
DIN Limit Controller (96 x 48mm) and P4700
8
and press
to force the controller into the Select Mode.
to navigate to the Configuration Mode option, then press
P6100, P8100 & P4100 Model Group
1
/
- DIN Controllers & Indicators - Product Manual
16
• 5 amp latching limit relay
• 2 Annunciators or process alarms
• Remote reset option
• Configuration via PC
1
/
16
1
/
DIN
4
.
59305, Issue 5 – March 2005
DIN
Advertisement
Table of Contents
