Table of Contents
Advertisement
1
1
1
/
-DIN,
/
-DIN &
/
4
8
16
8 P6100, P8100 & P4100 Controller – Model Group
These controllers combine technical functionality, field flexibility and ease of use to give you
the best in comprehensive process control. The P6100
1
P8100
/
–DIN Controller (96 x 48mm) and P4100
8
similar functionality in three DIN sizes.
• Heat/Cool operation
• Auto/Manual Tuning
• Two process alarms
• Ramping setpoint
P6100, P8100 & P4100 Controllers - Configuration Mode
This mode is normally used only when the instrument is configured for the first time or when
a major change is made to the controller characteristics. The Configuration Mode parameters
must be set as required before adjusting parameters in Setup Mode, or attempting to use the
instrument in an application.
Entry into the Configuration Mode
CAUTION:
Adjustments to these parameters should only be performed by personnel
competent and authorised to do so.
Configuration is entered from Select Mode
Hold down
then
Press
or
Note:
Entry into this mode is security-protected by the Configuration Mode Lock Code. Refer to
the Unlock Code section for more details.
Scrolling through Parameters and Values
Press
to scroll through the parameters (parameters are described below).
Note:
Only parameters that are applicable to the hardware options chosen will be displayed.
59305, Issue 5 – March 2005
- DIN Controllers & Indicators - Product Manual
and press
to force the controller into the Select Mode.
to navigate to the Configuration Mode option, then press
1
/
–DIN Controller (48 x 48mm),
16
1
/
–DIN Controller (96 x 96mm) offer
4
• Loop alarm
• Remote or Dual setpoint selection
• RS485 Modbus and ASCII comms
• Configuration via PC
Operating and Information Modes
.
Page 37
Advertisement
Table of Contents
