Table of Contents
Advertisement
P6100, P8100 & P4100 – Setup Mode
This mode is normally selected only after Configuration Mode has been completed, and is
used when a change to the process set up is required. It can affect the range of adjustments
available in Operator Mode. Using the PC Configurator software, it is possible to configure an
Extended Operator Mode. Setup Mode parameters are moved into Operator Mode, and
these parameters appear after the normal Operator Mode screen sequence has been
completed.
Note:
Entry into Setup Mode is security-protected by the Setup Mode lock code.
Entry into the Setup Mode
Hold down
Press
or
Setup Mode.
Scrolling through Parameters & Values
Press
to scroll through the parameters (refer to the table below) and their values.
Changing Parameter Values
Press
to select the required parameter, then press
required.
Once the displayed value is changed the effect is immediate. No confirmation of the
change is required.
Note:
If there is no key activity for two minutes the instrument returns to the operator mode.
Page 44
1
1
/
-DIN,
/
-DIN &
4
8
and press
to enter the Select Mode
to navigate to the Setup Mode option, then press
P6100, P8100 & P4100 Model Group
1
/
- DIN Controllers & Indicators - Product Manual
16
to enter
or
to set the value as
59305, Issue 5 – March 2005
Advertisement
Table of Contents
