1
1
1
/
-DIN,
/
-DIN &
/
4
8
16
7 Instrument Operation Modes
All instruments in the range share a similar user interface. Indicator models (single 4-digit
display) the legend shown in the "Lower Display" column will be shown for approx 1 second
before the "Upper Display" value is shown. For more details, refer to the mode tables below.
Model Group
P6100, P8100 &
'
P4100
P6600, P8600'
P6400
Select Mode
This mode is used to gain entry to each of the modes available in the instrument.
Entry into the Select Mode
Hold down
Navigating in Select Mode
Once in Select Mode, press
then press
To prevent unauthorised entry to Configuration, Setup and Automatic Tuning modes, an
unlock code is required. These are shown in the - Lock code values table.
Mode
Description
Operator
The Default Mode on power up
Mode
used for normal operation.
Set Up Mode
Used to tailor the instrument to
the application, adjustment of
tuning terms etc.
Configuration
Used to configure the
Mode
instrument for first time use or
on re-installation.
Product
Used to check the hardware,
Information
firmware and manufacturing
Mode
information of the instrument.
Automatic
Used to invoke
Tune Mode
self-tune
*Note:
On Indicators, this legend is shown for approx 1 second before the Main display value.
59305, Issue 5 – March 2005
- DIN Controllers & Indicators - Product Manual
Table 5. Model Groups
Description
Controllers
Controllers
Profile Controller
and press
in any mode to force the unit to enter Select Mode.
or
to enter the chosen mode.
Table 6. Select Mode Menus
pre-tune
or
on controllers
Model Group
P4700, P6700 &,
P8700
P6010 & P8010
to select the required mode,
Upper/Main
Display
Display (or
1
,1#9'
:;#1'
$"%&'
<%&"'
5#=%'
Operating and Information Modes
Description
Limit Controllers
Indicators
1
Lower
/
Indicator
st
Legend)*
Units Display
:+$#'
:+$#'
:+$#'
:+$#'
:+$#'
DIN
8
:'
:'
:'
:'
:'
Page 31