Panel Cut-Outs; Panel-Mounting; Figure 2. Panel Cut-Outs; Figure 3. Panel-Mounting The Instrument - WEST P8700 User Manual

Panel Cut-outs

The mounting panel must be rigid and may be up to 6.0mm (0.25 inches) thick. The cut-outs
required for the instruments are shown below.
92mm
+0.5 –0.0
+0.5 –0.0

Panel-Mounting

CAUTION:
Ensure the inside of the panel is with the instruments operating temperature and
that there is adequate air flow to prevent overheating.
Mounting Panel
Instrument Housing
Ratchets
Gasket
CAUTION:
Do not remove the panel gasket, as this may result in inadequate clamping and
sealing of the instrument to the panel.
Page 4
1 1
/ -DIN, /
4 8
1
/ DIN
4
92mm 45mm +0.5 –0.0
(92mm for indicator)
Figure 2. Panel cut-out sizes

Figure 3. Panel-Mounting the instrument

Installation
1
-DIN & / - DIN Controllers & Indicators - Product Manual
16
1
/ DIN
8
92mm
+0.5 –0.0
(45mm for
indicator)
1
/ DIN
16
45mm
+0.5 –0.0
45mm
+0.5 –0.0
Slide mounting clamp over the
instrument housing, towards rear face of
mounting panel, until the tongues
engage in ratchets and instrument is
clamped in position
Hold firmly in position
(apply pressure to bezel only)
59305, Issue 5 – March 2005
.