ABB ACQ550-x1-06A6-2 User Manual page 87

ACQ550-U1 User's Manual
Code Description
0136 COMM VALUE 2
Free data location that can be written from serial link.
0137 PROCESS VAR 1
Process variable 1
• Defined by parameters in
0138 PROCESS VAR 2
Process variable 2
• Defined by parameters in
0139 PROCESS VAR 3
Process variable 3
• Defined by parameters in
0140 RUN TIME
The drive's accumulated running time in thousands of hours (kh).
• Cannot be reset.
0141 MWH COUNTER
The drive's accumulated power consumption in megawatt hours.
• The counter value is accumulated till it reaches 65535 after which the counter rolls over and starts again from 0.
• Cannot be reset.
0142 REVOLUTION CNTR
The motor's accumulated revolutions in millions of revolutions.
• Can be reset by pressing UP and DOWN keys simultaneously when the control panel is in the Parameters mode.
0143 DRIVE ON TIME HI
The drive's accumulated power-on time in days.
• Cannot be reset.
0144 DRIVE ON TIME LO
The drive's accumulated power-on time in 2 second ticks (30 ticks = 60 seconds).
• Shown in format hh.mm.ss.
• Cannot be reset.
0145 MOTOR TEMP
Motor temperature in degrees Celsius / PTC resistance in ohms.
• Applies only if motor temperature sensor is set up.
• See parameter 3501.
0150 CB TEMP
Temperature of the drive control board in degrees Celsius.
0153 MOT THERM STRESS
Estimated rise of the motor temperature. Value equals to the estimated motor thermal stress as a percentage of the
motor temperature trip level.
0158 PID COMM VALUE 1
Data received from fieldbus for PID control (PID1 and PID2).
0159 PID COMM VALUE 2
Data received from fieldbus for PID control (PID1 and PID2).
0174 SAVED KWH
Energy saved in kWh compared to the energy used when the pump is connected directly to the supply. See the note
on page 156.
• The counter value is accumulated till it reaches 999.9 after which the counter rolls over and starts again from 0.0.
• Can be reset with parameter 4509
• See Group 45: ENERGY
0175 SAVED MWH
Energy saved in MWh compared to the energy used when the pump is connected directly to the supply. See the note
on page 156.
• The counter value is accumulated till it reaches 65535 after which the counter rolls over and starts again from 0.
• Can be reset with parameter 4509
• See Group 45: ENERGY
Group 34: PANEL DISPLAY.
Group 34: PANEL DISPLAY.
Group 34: PANEL DISPLAY.
(resets all energy calculators at the same time).
ENERGY RESET
SAVING.
(resets all energy calculators at the same time).
ENERGY RESET
SAVING.
87
Parameters