ABB ACQ550-x1-06A6-2 User Manual page 34

34
Apply input power.
Select MENU to enter the main menu.
Select ASSISTANTS with keys
Scroll to START-UP ASSISTANT with keys
The display then asks you to select the language. Scroll to the
desired language with keys
EXIT
If you press
The Start-up Assistant now guides you through the set-up tasks,
starting with the motor set-up. Set the motor data to exactly the
same value as on the motor nameplate.
Scroll to the desired parameter value with keys
SAVE
press to accept and continue with the Start-up Assistant.
Note: At any time, if you press
stopped and the display goes to the Output mode.
After completing a set-up task, the Start-up Assistant defaults to
application macro PID control.
OK
• Press (when
suggested task.
• Press key
the following task without doing the suggested task.
EXIT
• Press to stop the Start-up Assistant.
SAVING A USER PARAMETER SET AND FINAL CHECK
The start-up is now completed. However, it might be useful at this
stage to set the parameters required by your application and save
the settings as a user parameter set as instructed in section
parameter sets
After the whole set-up is completed, check there are no faults or
alarms shown on the display and the panel LED is green and does
not blink.
Start-up, control with I/O and ID Run
POWER-UP
/
SELECTING THE LANGUAGE
/
, the Start-up Assistant is stopped.
STARTING THE GUIDED SET-UP
EXIT
, the Start-up Assistant is
is highlighted) to continue with the
Continue
to highlight and then press
Skip
on page 66.
The drive is now ready for use.
and select ENTER.
/ .
SAVE
and press to accept.
/ and
OK
to move to
User
ACQ550-U1 User's Manual