ABB ACQ550-x1-06A6-2 User Manual page 48

48
Name
Speed control EXT1 Selecting the source for the speed reference
Speed control EXT2 Selecting the source for the speed reference
Start/Stop control
Timed functions
Protections
Output signals
Changed Parameters Mode
To view (and edit) a listing of all parameters that have been changed from macro
default values, follow these steps:
1
2
3
Control panel
Description (Continued)
(If AI1 is used: Setting analog input AI1 limits, scale, inversion)
Setting the reference limits
Setting the speed (frequency) limits
Setting the acceleration and deceleration times
(If AI1 is used: Setting analog input AI1 limits, scale, inversion)
Setting the reference limits
Selecting the source for start and stop signals of the two external control
locations, EXT1 and EXT2
Selecting between EXT1 and EXT2
Defining the direction control
Defining the start and stop modes
Selecting the use of Run Enable signal
Setting the timed functions
Selecting the timed start/stop control for external control locations EXT1 and
EXT2
Selecting timed EXT1/EXT2 control
Activation of timed constant speed 1
Selecting timed function status indicated through relay output RO
Selecting timed PID1 parameter set 1/2 control
Setting the current and torque limits
Selecting the signals indicated through relay output RO
Selecting the signals indicated through analog output AO
Setting the minimum, maximum, scaling and inversion
Select MENU to enter the menu.
Select CHANGED PAR with the UP/
DOWN buttons and select ENTER.
A list of changed parameters is displayed.
Select EXIT to exit the Changed
Parameters Mode.
ACQ550-U1 User's Manual