ABB ACQ550-x1-06A6-2 User Manual page 37

ACQ550-U1 User's Manual
• Motor nominal current (parameter 9906)
Allowed range: 0.2...2.0 · I
• Motor nominal frequency (parameter 9907)
• Motor nominal speed (parameter 9908)
• Motor nominal power (parameter 9909)
Select the motor identification method (parameter 9910).
The default value 0 (
applications. It is applied in this basic start-up procedure. Note however that this requires
that:
• parameter 9904
• parameter 9904
or 5 ( +
FLY BOOST
If your selection is 0 (
Value 1 ( ), which performs a separate ID Run, should be selected if:
ON
• vector control mode is used [parameter
• the operation point is near zero speed, and/or
• operation at torque range above the motor nominal torque over a wide speed range and
without any measured speed feedback is required.
If you decide to do the ID Run [value 1 (
given on page
OF THE MOTOR ROTATION
A
2hd
/ ) using the identification magnetization is suitable for most
OFF IDMAGN
is set to 1 or 2 (
VECTOR
is set to 3 (
SCALAR
).
/ ), move to the next step.
OFF IDMAGN
40 in section How to perform the ID Run
on page 38.
: ), or
SPEED
: ) and parameter
FREQ
9904 = 1 or 2 (
VECTOR
)], continue by following the separate instructions
ON
and then return to step
2101 is set to 3 (
SCALAR FLYST
: )],
SPEED
DIRECTION
Start-up, control with I/O and ID Run
37
)