ABB ACQ550-x1-06A6-2 User Manual page 41

ACQ550-U1 User's Manual
Change parameter
SAVE
by pressing
If you want to monitor actual values during the ID Run, go to
the Output mode by pressing
there.
Press to start the ID Run. The panel keeps switching
between the display that was shown when you started the ID
Run and the alarm display presented on the right.
In general, it is recommended not to press any control panel
keys during the ID Run. However, you can stop the ID Run at
any time by pressing
After the ID Run is completed, the alarm display is not shown
any more.
If the ID Run fails, the fault display presented on the right is
shown.
ID RUN WITH THE ACQ CONTROL PANEL
9910 to 1 (
ID RUN ON
.
EXIT
repeatedly until you get
.
). Save the new setting
Start-up, control with I/O and ID Run
LOC PAR EDIT
9910 ID RUN
ON
[1]
CANCEL 00:00 SAVE
50.0Hz
LOC
0. 0 Hz
0. 0 A
0. 0 %
DIR 00:00 MENU
LOC ALARM
ALARM 2019
ID run
00:00
LOC FAULT
FAULT 11
ID RUN FAIL
00:00
41