ABB ACQ550-x1-06A6-2 User Manual page 168

168
Code Description
• The table below shows the ACQ550 PFC motor assignments for some typical settings in the Relay Output
parameters (1401...1403 and 1410...1412), where the settings are either =31 (
where the Autochange function is disabled (8118
Parameter setting
1 1 1 1 1
4 4 4 4 4
0 0 0 1 1
1 2 3 0 1
31 X X X X X 1
31 31 X X X X 2
31 31 31 X X X 3
X 31 31 X X X 2
X X X 31 X 31 2
31 31 X X X X 1*
* = One additional relay output for the PFC that is in use. One motor is in "sleep"
when the other is rotating.
• The table below shows the ACQ550 PFC motor assignments for some typical settings in the Relay Output
parameters (1401...1403 and 1410...1412), where the settings are either =31 (
where the Autochange function is enabled (8118
Parameter setting
1 1 1 1 1
4 4 4 4 4
0 0 0 1 1
1 2 3 0 1
31 31 X X X X
31 31 31 X X X
X 31 31 X X X
X X X 31 X 31 1
31 31 X X X X 0**
** = No auxiliary motors, but the autochange function is in use. Working as a
standard PID-control.
8118 AUTOCHNG INTERV
Controls operation of the Autochange function and sets the
interval between changes.
• The Autochange time interval only applies to the time when
the speed regulated motor is running.
• See parameter 8119
Autochange function.
• The drive always coasts to stop when autochange is
performed.
• Autochange enabled requires parameter 8120
value > 0.
-0.1 = – Forces the interval to value 36...48 s.
TEST MODE
0.0 = – Disables the Autochange function.
NOT SEL
0.1...336 – The operating time interval (the time when the start
signal is on) between automatic motor changes.
WARNING! When enabled, the Autochange function
requires the interlocks (8120
enabled. During autochange the power output is
interrupted and the drive coasts to stop, preventing
damage to the contacts.
Parameters
ACQ550 Relay assignment
1 8 Autochange disabled
4 1
RO1 RO2
1 1
2 7
Aux. X
Aux. Aux.
Aux. Aux.
X Aux.
X X
Aux. Aux.
ACQ550 Relay assignment
1 8 Autochange enabled
4 1
RO1 RO2
1 1
2 7
1 PFC PFC
2 PFC PFC
1 X PFC
X X
PFC PFC
for an overview of the
AUTOCHNG LEVEL
INTERLOCKS
= 0.0).
AUTOCHNG INTERV
RO3 RO4 RO5
X X X
X X X
Aux. X X
Aux. X X
X Aux. X
X X X
= value > 0.0).
AUTOCHNG INTERV
RO3 RO4 RO5
X X X
PFC X X
PFC X X
X PFC X
X X X
ACQ550
=
INTERLOCKS
= value > 0)
ACQ550-U1 User's Manual
), or =X (anything but 31), and
PFC
RO6
X
X
X
X
Aux.
X
), or =X (anything but 31), and
PFC
RO6
X
X
X
PFC
X
Relay logic
PFC with Autochange mode