Landoll VT Plus 7431 Operator's Manual page 82

OPERATION AND MAINTENANCE
5. To fold/unfold the VT Plus, find a level area large
enough to accommodate the VT Plus when it is fully
unfolded. The tractor should be stopped and not
moving with the unit fully raised. Remove the wing
lock pins from the mounts and install them in the
storage locations (See Figures 4-6 and 4-7).
IMPORTANT
Failure to remove the lock pins when unfolding will
result in serious damage to the implement. Be sure
other people and pets are a safe distance away.
6. Slowly engage the tractor lever and fold/unfold the
wing frames. When the wings are unfolded, continue
holding the tractor lever to fully extend all fold
cylinders. This will allow the wings to fully flex in the
field.
7. When the unit is fully folded, remove the wing lock
pins from the storage location and install in the
mounts provided on each side of the machine.
8. If wing lock pin or plates are bent or deformed during
unfolding procedure, replacement parts may be
ordered (wing lock pin p/n 2-557-010409 and wing
lock plate p/n 171026).
4-6
3/16 HAIR PIN
WING STABILIZER
BRACKET
1/4 X 3 ROLL PIN
WING LOCK PIN
WING LOCK PLATE
7431 installed locks
Figure 4-6: Installed Transport Locks
3/16 HAIR PIN
WING STABILIZER
BRACKET
1/4 X 3
ROLL PIN
WING LOCK PIN
WING LOCK PLATE
7431 stored locks
Figure 4-7: Stored Transport Locks
F-561-0818