Hitch Adjustment - Landoll VT Plus 7431 Operator's Manual

OPERATION AND MAINTENANCE

Hitch Adjustment

1. It is important for the VT Plus to maintain a proper
draft line with the tractor to do a level job of discing.
The draft line will vary depending on soil conditions
and tractor drawbar height. The VT Plus is equipped
with an adjustable hitch to help insure a proper draft
line with the tractor.
2. Generally tractor drawbars greater than 17" tall will
require the hitch to be in the upper position. 17"
drawbars and below should be in the lower position.
Operating conditions may also influence the hitch
adjustment. The hitch is most commonly located in
the upper position.
3. A hitch adjustment that is too high will leave a center
furrow, as the front of the VT Plus will operate too
deep. A low hitch adjustment can cause a center
ridge, regardless of leveler setting.
IMPORTANT
Excessive down pressure with gauge wheels can
also create a center ridge regardless of hitch and
leveler settings.
LEVELER BALL
JOINT LINK
1-8 X 4 HEX
HEAD CAP
SCREW AND
HARDWARE
HITCH WELDMENT
6230hitchadj
Figure 4-15: Hitch Adjustment
4-12
4. To adjust the hitch (See Figure 4-15.):
a. Lower the VT Plus to the ground.
b. Adjust the leveler screw (manual or hydraulic) in
or out until the pressure is relieved on the
leveling system (See "Leveling (Side to Side)"
on page 4-8 and "Leveling (Front-to-Rear)" on
page 4-10).
c. Remove the 1-8 X 4 hex head cap screw and
hardware from the leveler ball joint link at the
center rear of the hitch weldment.
d. Loosen, but do not remove the bolts that pass
through the ball joint connections at the outer
rear connections of the hitch.
e. Remove the bolt through the two hole clamp
plates (above or below) the rear connections of
the hitch ball joint.
f. Vertically raise or lower the hitch to the desired
operating position.
g. Reinstall the bolt through the two-hole clamp
plates to secure the hitch in the new position.
h. Retighten all hitch bolts.
i. Install the bolt in the leveler ball joint link in the
new position at the rear of the hitch and
retighten.
IMPORTANT
When the hitch is in the lower position, the leveler
ball joint link will be in the upper mounting hole at
the rear of the tongue. If the hitch is in the raised
mounting position, the leveler ball joint link will be in
the lower hole at the rear of the tongue.
F-561-0818