Table of Contents
Advertisement
ET635 User Manual
U
sing the phone
This section describes the functions of the phone with the factory default settings. If your phone was installed
and/or set up by someone else, the default settings may have been changed. Please check with that person or
company if the phone does not react as described here.
The caller information displayed on the screen is controlled by a setting on the phone's web interface. The
default setting is "Name Number". You can change the setting at the Preferences tab > Appearance tab >
General Information section > "Number Display Style" by selecting a different option from the drop-down list.
M
aking calls
See "Entering numerals, letters, special characters, and symbols" on page 27 for information on input modes
and entering letters, numerals, and special characters.
Selecting identity for current outgoing call
See "Identities/accounts" on page 89 on how to configure identities.
If more than one identity is shown on the display, the one on the white bar with the white
and green rings around the green circle is the outgoing identity for the call and the number/
name that will show on the callee's phone. Use the up or down arrow on the navigation key
to select another identity.
Using different audio devices
Handset
•
Pick up the handset, enter the phone number, and press
•
enter the phone number and pick up the handset.
Headset
Enter the phone number and press
Speakerphone
Enter the phone number and press
Handset or headset and casing speaker
With dual audio mode activated, other persons present in the room are allowed to listen in to the third party
over the phone's casing loudspeaker.
1. Use the method for handset or headset use to dial.
2. When the call has been established, press
speaker off.
.
.
to enable the casing loudspeaker. Press
56
OR
Using the Phone
to turn the
Advertisement
Table of Contents
