Table of Contents
Advertisement
e
Push the spool cap onto the spool pin as far
as possible, then return the spool pin to its
original position.
CAUTION
• If the thread spool and/or spool cap are set
incorrectly, the thread may tangle on the spool
pin and cause the needle to break.
• Use the spool cap (large or medium) or the
thread spool insert (mini king thread spool)
that is closest in size to the thread spool. If a
spool cap smaller than the thread spool is
used, the thread may become caught in the slit
on the end of the spool and cause the needle
to break.
Memo
• When embroidering with fine, cross-wound
thread, use the small spool cap, and leave a
small space between the cap and the
thread spool.
a Spool cap (small)
b Thread spool (cross-wound thread)
c Space
• If a spool of thread whose core is 12 mm (1/
2 inch) in diameter and 75 mm (3 inches)
high is inserted onto the spool pin, use the
thread spool insert (mini king thread spool).
a Thread spool insert (mini king thread spool)
b 12 mm (1/2 inch)
c 75 mm (3 inches)
f
While holding the thread with both hands,
pull the thread up from under the thread
guide plate.
a
a Thread guide plate
g
While holding the thread in your right
hand, pass the thread through the thread
guide in the direction indicated.
h
Guide the thread down, up, then down
through the groove, as shown in the
illustration.
Memo
• Look in the upper groove area to check if
the thread catches on the thread take-up
lever visible inside the upper groove area.
a Look in the upper groove area
UPPER THREADING
1
23
Advertisement
Table of Contents
