Table of Contents
Advertisement
o
Pull out about 100-150 mm (approx. 4-6
inches) of the thread, and then pass it under
the embroidery foot toward the rear of the
machine.
Raise the presser foot lever if the embroidery foot is
lowered.
a
a About 100-150 mm (approx. 4-6 inches)
Memo
• If the needle could not be threaded or the
thread was not passed through the needle
bar thread guides, perform the procedure
again starting from step
Then, pass the thread through the eye of
the needle after step
Note
• Some needles cannot be threaded with the
needle threader. In this case, instead of
using the needle threader after passing the
thread through the needle bar thread guide
(marked "6"), manually pass the thread
through the eye of the needle from the front.
Using the Spool Stand
The included spool stand is useful when using
thread on spools with a large diameter (cross-
wound thread). This spool stand can hold two
spools of thread.
Memo
• Refer to the Operation Manual (Sewing) to
assemble the spool stand.
• Refer to page 19 to wind the bobbin when
using the spool stand.
■ Using the Spool Stand
• Be sure to use a spool cap that is slightly larger
than the spool.
If the spool cap that is used is smaller or much
c
.
i
.
larger than the spool, the thread may catch and
embroidering performance may suffer.
• When using thread on a thin spool, place the
included spool felt on the spool pin, place the
thread spool on the spool pin so that the center
of the spool is aligned with the hole at the center
of the spool felt, and then insert the spool cap
onto the spool pin.
a Spool felt
• When using thread on a cone spool, use the
spool holder. When using cone shaped thread
spool with other than cotton thread, it is not
necessary to use spool caps.
a Spool holder
• Depending on the size of spool or the amount of
thread remaining, choose the appropriate sized
spool cap (large or medium). Spool cap (small)
cannot be used with the spool cap base.
a
a Spool cap
b Spool cap base
UPPER THREADING
1
25
Advertisement
Table of Contents
