Table of Contents
Advertisement
LOWER THREADING
c
Push the bobbin winder switch to the right,
and then raise the bobbin at least 100 mm
(4 inches) from the shaft.
d
Cut the thread near the bobbin and hold the
thread end of the spool with your left hand.
Unwind the thread clockwise near the
bobbin winder seat with your right hand as
shown below.
e
Wind the bobbin again.
Note
• Make sure that the thread passes through
the pretension disk correctly (page 16).
20
Setting the Bobbin
CAUTION
• Use a bobbin thread that has been correctly
wound. Otherwise, the needle may break or
the thread tension will be incorrect.
• The included bobbin was designed specifically
for this machine. If bobbins from other models
are used, the machine will not operate
correctly. Use only the included bobbin or
bobbins of the same type (part code: SA156,
(SFB: XA5539-151 / 115J05E0001)). SA156 is
Class 15 type bobbin.
• Before inserting or changing the bobbin, be
sure to press
and buttons, otherwise injuries may occur if
the "Start/Stop" button or any other button is
pressed and the machine starts embroidering.
a
Press
to lock all keys and buttons and
raise the embroidery foot.
*
If the message "OK to automatically lower the
presser foot?" appears on the LCD screen, press
to continue.
b
Slide the bobbin cover latch to the right.
a
a Bobbin cover
b Latch
The bobbin cover opens.
in the LCD to lock all keys
Advertisement
Table of Contents
