Table of Contents
Advertisement
f
Pass the thread through the thread guide.
a Thread guide
g
Pass the thread around the pretension disk
making sure that the thread is under the
pretension disk.
a Thread guide
b Pretension disk
h
g
Follow steps
through
through 18.
■ Using the Spool Stand
To wind thread on the bobbin while the spool stand
is installed, pass the thread from the spool through
the thread guide on the telescopic thread guide, and
then wind the bobbin according to steps
k
of "Using the Supplemental Spool Pin"on
page 16 to page 18.
a
a
k
on page 16
e
through
Memo
• Refer to the Operation Manual (Sewing) to
assemble the spool stand.
• Refer to page 25 to thread the machine
using the spool stand.
CAUTION
• When winding thread on the bobbin, do not
cross the bobbin winding thread with the
upper thread in the thread guides.
■ Untangling Thread from Beneath the
Bobbin Winder Seat
If the bobbin winding starts when the thread is not
passed through the pretension disk correctly, the
thread may become tangled beneath the bobbin
winder seat.
Wind off the thread according to the following
procedure.
a Thread
b Bobbin winder seat
CAUTION
• Do not remove the bobbin winder seat even if
the thread becomes tangled under the bobbin
winder seat. It may result in injuries.
a
If the thread becomes tangled under the
bobbin winder seat, press
stop the bobbin winding.
b
Cut the thread with scissors near the
pretension disk.
a
a Pretension disk
LOWER THREADING
once to
19
1
Advertisement
Table of Contents
