Table of Contents
Advertisement
UPPER THREADING
a
Attach the spool stand to the machine.
b
Place the spool of thread on the spool pin
so that the thread feeds off the spool
clockwise. Firmly insert the spool cap onto
the spool pin.
Note
• When using 2 spools of thread, make sure
that both spools are feeding in the same
direction.
• Make sure that the spools do not touch
each other, otherwise the thread will not
feed off smoothly, the needle may break, or
the thread may break or become tangled. In
addition, make sure that the spools do not
touch the telescopic thread guide at the
center.
• Make sure that the thread is not caught
under the spool.
26
c
Pull the thread off the spool. Pass the thread
from the back to the front through the
thread guides at the top.
When using thread that quickly feeds off the spool,
such as metallic thread, use the enclosed ring to
prevent the thread from becoming entangled.
Threading sequence; Pull the thread from the spool,
place the thread through the ring from the bottom up
(1), into the thread guide (2) and through the ring
from the top down (3). When using the ring, do not
use the spool cap base.
Note
• Guide the thread so that it does not become
entangled with the other thread.
• After feeding the thread as instructed, wind
any excess thread back onto the spool,
otherwise the excess thread will become
tangled.
d
Pass the thread through the machine's
thread guide from the right to the left.
a Thread guide
e
Thread the machine according to the steps
f
o
to
of "Upper Threading" on page 22.
2
3
1
a
Advertisement
Table of Contents
