Table of Contents
Advertisement
LOWER THREADING
k
Cut the thread with cutter and remove the
bobbin.
a Cutter
Memo
• When removing the bobbin, do not pull on
the bobbin winder seat. Doing so could
loosen or remove the bobbin winder seat,
and could result in damage to the machine.
CAUTION
• Setting the bobbin improperly may cause the
thread tension to loosen, breaking the needle
and possibly resulting in injury.
■ Using the Spool Pin
You can use the main spool pin to wind the bobbin
before embroidering. You cannot use this spool pin
to wind the bobbin while embroidering.
a
Turn the main power to ON and open the
top cover.
18
b
Align the groove in the bobbin with the
spring on the bobbin winder shaft, and set
the bobbin on the shaft.
a
a Groove in the bobbin
b Spring on the shaft
c
Pivot the spool pin so that it angles upward.
Set the thread spool on the spool pin so that
the thread unwinds from the front of the
spool.
a Spool pin
b Spool cap
c Thread spool
d Spool felt
d
Push the spool cap onto the spool pin as far
as possible, then return the spool pin to its
original position.
e
While holding the thread with both hands,
pull the thread up from under the thread
guide plate.
a
a Thread guide plate
Advertisement
Table of Contents
