Preventative Maintenance Schedule; P R E V E N T A T I V E M A I N T E N A N C E S C H E D U L E; Warnings And Cautions; Wa R N I N G S A N D C A U T I O N S - Conair FLX-128 User Manual

5 - 2 l M a i n t e n a n c e

P r e v e n t a t i v e m a i n t e n a n c e s c h e d u l e

No specific maintenance schedule is required for the FLX since there are no moving
parts. All components of the system are electrical in nature, but like any component in a
factory, can be prone to unforeseen breakage.
In the event of breakage, replace the component(s). Do not attempt repair.
• Monthly, or as often as needed
Check that the cables and junction boxes associated with the FLX.
Make sure all cables are intact, undamaged, out of harm's way, etc.
Ì Correct the mounting integrity of all control boxes as required and re-route
the communication cables to avoid high amperage electrical lines and/or
moving, hot or sharp objects.

Wa r n i n g s a n d C a u t i o n s

WA R N I N G : I m p r o p e r I n s t a l l a t i o n , o p e r a t i o n , o r s e r v -
i c i n g m a y r e s u l t i n e q u i p m e n t d a m a g e o r p e r s o n a l
i n j u r y.
This equipment should only be installed, adjusted, and serviced by qualified technical
personnel who are familiar with the construction, operation, and potential hazards of this
type of machine.
All wiring, disconnects, and fuses should be installed by qualified electrical technicians in
accordance with electrical codes in your region. Always maintain a safe ground. Do not
operate the equipment at power levels other than what is specified on the machine serial
tag and data plate.
WA R N I N G : Vo l t a g e h a z a r d
This equipment is powered by electrical current, as specified on the machine
serial tag and data plate. Do not operate the equipment at power levels other
than what is specified on the machine serial tag and data plate.
A properly sized conductive ground wire from the incoming power
supply must be connected to the chassis ground terminal inside the electrical
enclosure. Improper grounding can result in severe personal injury and erratic
machine operation.
Before performing maintenance or repairs on this product, disconnect and lock
out electrical power sources to prevent injury from unexpected energization or
start-up. Always follow your company's internal lockout/tagout procedure for all main-
tenance and service.