Assign A Backup Pump; Test Pump - Conair FLX-128 User Manual

P u m p S c r e e n
Pressing the Pump icon opens the Pump Detail
window.
The following is displayed:
•
Pump Starts – The number of times the pump is commanded to turn on.
•
PM Setpoint – The number of start times used as a setpoint for maintenance.
•
Duty Cycle - The percentage the pump is running while enabled.
A s s i g n a B a c k u p P u m p
This feature allows a pump to be backed up in the event it fails or needs service. One or two
backup pumps are available based upon I/O configuration.
1
Disable the pump.
2
Press the pump icon from the Pump Screen to see the pump detail.
3
Press the Assign to Backup button for the pump you would like to use.
To remove the pump from the backup pump, repeat steps 1 and 2, then press the Unassign from
Backup Pump button.
Te s t P u m p
This feature allows the output to the pump starter to be energized.
1
Disable the pump.
2
Press the pump icon from the Pump Screen to see the pump detail.
3
Press the Test Pump button. While the pump is being tested, the pump detail screen will remain
open.
4
Once complete, press Test Pump again.
( c o n t i n u e d )
i
NOTE: The pump must be
disabled, and the user must
be logged in with the appro-
priate security level to access
and change some settings.
O p e r a t i o n l 4 - 2 7