Changing Network Addresses For Remote Alarms - Conair FLX-128 User Manual

C h a n g i n g N e t w o r k A d d r e s s e s f o r
R e m o t e A l a r m s ( Wa g o 3 5 2 )
1
Verify that the PC to be con-
nected is on the same net-
work as the FLX remote
alarms. This can be done by
looking at Control Panel -
Network Connections - Local
Area Connection.
2
Connect the PC to the FLX
system network using an
Ethernet cable. A spare
Ethernet port can be found in
the main cabinet.
3
Once the PC is connected,
open up Internet Explorer on
the PC.
4
In the address bar type http://{current IP address of FLX controller}. Example:
http://10.1.61.1
( C o n t i n u e d )
I n s t a l l a t i o n l 3 - 2 1