F L X S e t u p
Pump Names
The Pump Names screen is used to customize/change the name of
the pump. The number of pumps shown is based upon the I/O con-
figuration.
Source Names
The Source Names screen is used to customize/change the name of
the source. The number of sources displayed is based upon I/O
configurations and if device output options have been configured
for either purge or pocket.
Device Setup
The Device Setup screen is used to setup the device which includes
the following: device type, pump or multi-source loader assign-
ment, select the output option(s), and to name the device. Number
of devices and output options availability is based upon I/O config-
urations. In order to setup the device, the device must be disabled.
To setup a device press the device number located in the device
column. Follow the steps provided on the pop-up screen.
To change the name of the device press the name of the device in
the name column and enter new name.
PM/Maint Setup
•
The PM Setup screen is used to setup the set points for
PM/maint for the valves (load, discharge, purge, ratio) and pump
cycles.
•
An alarm can be activated for Maintenance for either the device
or pump by enabling the alarm.
•
The device current counters can be reset by following the steps
outlined on the screen.
( c o n t i n u e d )
O p e r a t i o n l
4 - 4 7