Ip Configuration Menu - Omnia .9 Installation & User Manual

SYSTEM MENU
Note:
If you have one of the earliest units, (serial number 0025 and earlier), once the screen is asleep, it cannot be
woken by touch, due to a hardware issue. In this case, you can wake the screen from NfRemote by pressing
the Wake Display button in order to access the front panel.
The Wake Display menu allows you to reset the internal LCD display on the physical unit, in case it becomes
♦
unresponsive.

IP Configuration Menu

The IP Configuration menu allows you to assign IP addresses for WAN and Livewire / AoIP network adapters, enter subnet
mask and gateway information for your network(s), and enter DNS addresses.
The Use DHCP button allows your local router to assign an IP address to the unit.
♦
Selecting Apply puts any changes you have made to these parameters into effect after a few seconds.
♦
The Livewire IP configuration menu has similar controls to the WAN menu, and also provides Livewire Clock status and
♦
a Share Wan Port control.
When enabled, Share Wan Port allows all network traffic to travel over a single network connector (marked WAN on the
♦
rear panel). This control is useful for facilities that don't have segregated Data and Livewire/AoIP networks.
CHAPTER 23 |
191