Pre-Emph Input Menu; Display Settings Menu - Omnia .9 Installation & User Manual

FM MENU MPX INPUTS

Pre-emph Input Menu

The Pre-emph Input menu contains the controls to choose and adjust the physical input, pre-emphasis, delay, and equalization
settings. The Pre-emph Input is similar to the MPX Inputs, but is specifically for use with the L/R Outputs from another
processor. This input can receive audio from any of the three digital inputs. The analog input is not suitable as it is not DC
coupled.
The Physical Input control determines which rear-panel input is routed to the pre-emph input patch point.
♦
The Source control selects whether the input source is flat or pre-emphasized.
♦
The Pre-emphasis control should be set to match the amount of pre-emphasis the incoming signal has (or used to have if
♦
it was de-emphasized prior to being fed into Omnia.9).
The Add Delay control allows you to delay the audio coming in from the pre-emphasis input to match that of the
♦
Omnia.9.
The PEQ button enables the 2-band parametric equalizer. When the PEQ is enabled, the sliders to adjust center
♦
frequency, width, and gain are available to make any necessary adjustments. The PEQ can be set to be phase linear, phase
forward, or phase reverse via the drop-down menu below the gain slider.

Display Settings Menu

The Display Settings menu is the same menu found in the Processing Menu of the Processing section, and is duplicated here for
convenience.
CHAPTER 16 |
119