Mb Agc Levels - Omnia .9 Installation & User Manual

FM MENU EXPERT MODE

MB AGC Levels

The AGC Target controls set the target gain reduction / output level of the MB AGC bands individually or overall with the
♦
"coupled" control. A lower setting results in more gain reduction thus a corresponding lower output level while higher
settings provide less gain reduction and a higher output level. This is similar to a traditional "threshold" control when the
levels are below the target.
The Band Mix column within the Multiband AGC/MB AGC Levels allows you to adjust the final output of each band
♦
after all Wideband and Multiband processing has been applied. This is the same Band Mix that is a separate tab under the
Processing path. It is provided here as a convenience. It can be used very effectively to tailor the overall spectral balance
of your sound, but keep in mind that this is the final point of adjustment before the audio reaches the Final Clipper (FM
core) or Final Limiter (HD and Streaming Cores). In other words, levels increased in the Band Mix section can only be
controlled by final clipping or final limiting, which may result in unexpected or unwanted density on some material, so
care is required when making adjustments here.
The Drive controls adjust the amount of drive (input level) to the AGC bands individually or overall with the "coupled"
♦
control. Drive differs from Target in that higher settings of Drive actually raise the input level to the AGC band or section,
increasing gain reduction but not changing the output level. Depending on other AGC parameters, the output may
change due to other factors, but the output level set point does not change.
CHAPTER 12 |
79