System Configuration; Input Configuration; Output Configuration - Omnia 11 Quick Start Installation Manual

sysTEm CONFIGURATION

INPUT CONFIGURATION

1. Touch the "ADJ" icon (BB) to return to the initial System screen.
2. Touch the "Input" icon (CC). The Input Configuration screen will be displayed. If the "Basic" tab (DD)
is not active, touch to select it.
CC
BB
FF
3. From the "Input Source" drop-down (EE), select the Analog, AES/EBU or Livewire input as appropriate
for your installation. If your audio source is providing an audio feed you should see meter activity on
the bargraph meters (FF).
4. While driving the inputs with typical program material at normal operating level, adjust the
appropriate "Master" Input Gain control (GG) for your installation until the peak-reading input bar
graph meters are reading just "into the yellow" (about –15 to –12 dBFS or so). If the left/right audio
levels coming into the Omnia.11 are somewhat unbalanced, you can adjust the "Right Trim" control
(HH) to change the level of the right channel alone over a limited range.

OUTPUT CONFIGURATION

1. T ouch the "Output" icon (II). The Output Configuration screen will be displayed. If the "Basic" tab is not
active, touch to select it.
DD
GG
HH
EE
II