Table of Contents
Advertisement
Hardware Installation and Connection
This chapt er shows you how t o inst all and connect t he Swit ch.
1.1 Installation Scenarios
The Swit ch can be placed on a deskt op or rack- m ount ed on a st andard EI A rack. Use t he rubber
feet in a deskt op inst allat ion and t he bracket s in a rack- m ount ed inst allat ion.
Not e: For proper vent ilat ion, allow at least 4 inches ( 10 cm ) of clearance at t he front and
3.4 inches ( 8 cm ) at t he back of t he Swit ch. This is especially im por t ant for
enclosed rack inst allat ions.
1.2 Desktop Installation Procedure
Make sure t he Swit ch is clean and dry.
1
Set t he Swit ch on a sm oot h, level surface st rong enough t o support t he weight of t he Swit ch and
2
t he connect ed cables. Make sure t here is a power out let nearby.
Make sure t here is enough clearance around t he Swit ch t o allow air circulat ion and t he at t achm ent
3
of cables and t he power cord.
1.3 Mounting the Switch on a Rack
The Swit ch can be m ount ed on an EI A st andard size, 19- inch rack or in a wiring closet wit h ot her
equipm ent . Follow t he st eps below t o m ount your Swit ch on a st andard EI A rack using a rack-
m ount ing kit .
1.3.1 Rack-mounted Installation Requirements
• Two m ount ing bracket s.
• Eight M3 flat head screws and a # 2 Philips screwdriver.
• Four M5 flat head screws and a # 2 Philips screwdriver.
Failure to use the proper screws may damage the unit.
C
H A P TE R
MGS3750-28F User's Guide
7
1
Advertisement
Table of Contents
