Operating Buttons; Start Up; Adjusting Temperature; Run Mode - Uponor Climate Control Zoning System II Installation And Operation Manual

Operating buttons

The figure below shows buttons used to operate the
digital thermostats.
A
Figure 7-3: Digital thermostat operating buttons
Item
A
The – and + buttons are used to:
• Adjust setpoint temperature
B
• Modify parameters in the settings menus
C
The OK button is used to:
• Toggle between current status data as well as values of
available sensors connected to the thermostat
• Enter and exit the settings menu
• Confirm a setting

Start up

When starting up, the software version is shown in the display
for about 3 seconds. Then the thermostat enters run mode.
Note: The first time the thermostat is started, or after a factory
reset, the software requires the time and date to be set.

Adjusting temperature

Change the temperature by adjusting the setpoint
on the thermostat.
Use the buttons on the thermostat to adjust the temperature.
The display will light up when pushing a button. It shuts off
after about 10 seconds of inactivity.
The illustration below shows how to adjust the thermostat
temperature setpoint.
Figure 7-4: Adjusting temperature
26 | uponorpro.com
B
C
Description
To adjust the thermostat temperature setpoint of the current
control mode:
1. Press the – or + button once.
The screen shows the current setpoint flashing.
Figure 7-5: Temperature setpoint screen
2. Press the - or + button repeatedly to adjust the setpoint
temperature. It will change with increments of 0.5.
When the new setpoint is set, the screen returns to run
mode after a few seconds, showing the room temperature.

Run mode

During normal operation, the thermostat is in run mode.
While in run mode the display shows specific information.

Settings

This menu sets thermostat parameters.
Note: If no button is pressed for about 8 seconds, while
in a submenu, the current values will be saved and the
software exits to the settings menu. About 60 seconds later, it
exits to run mode.
To enter the settings menu:
1. Press and hold the OK button for about 3 seconds.
2. The settings icon and menu numbers is displayed
in the top right corner of the display.
3. Use buttons – or + to change the numbers to locate a
submenu (see list below) and press OK.
00 = Program
1
02 = Heating/cooling changeover
03 = ECO mode setback temperature
04 = Sensor options
05 = High floor temperature limitation
06 = Low floor temperature limitation
07 = Cooling allowed
1
08 = Display unit
09 = Climatic controller integration
10 = Time and date
1
11 = Room temperature calibration
1
Not active in this release.
2 This menu is not visible if the thermostat is registered to a controller.
4. Change parameters in the submenus.
5. Press and hold the OK button for about 3 seconds to
exit the settings menu.
1, 2
1
1