Low Floor Temperature Limitation; Display Unit; Room Temperature Calibration; Replacing Batteries - Uponor Climate Control Zoning System II Installation And Operation Manual

Low floor temperature limitation

This menu sets the limit on the minimum allowable floor
temperature.
To change this setting:
1. Press OK and the parameter starts flashing.
2. Use buttons – or + to change the parameter.
Default: 68ºF (20ºC)
Setting range: 50ºF to 86ºF (10ºC to 30ºC),
0.5 increments
Important! If this parameter is set lower than
60.8ºF (16ºC) the cooling icon will start flashing,
warning for risk of condensation in the system.
Important! This parameter cannot be set higher
than the set value in settings menu High floor
temperature limitation.
3. Press OK to confirm the change and return to the
settings menu.

Display unit

This menu sets the temperature display unit.
To change this setting:
1. Press OK and the parameter starts flashing.
2. Use buttons – or + to toggle between Celsius and Fahrenheit.
DEg ºC: degrees Celsius
DEg ºF: degrees Fahrenheit
3. Press OK to confirm the change and return to the
settings menu.

Room temperature calibration

This menu calibrates the room temperature.
To change this setting:
1. Press OK and the parameter starts flashing.
2. Use buttons – or + to change the parameter.
Default: 0.0 ºC
Setting range: -6.0 to 6.0 ºC, 0.1 increments
3. Press OK to confirm the change and return to
the settings menu.
28 | uponorpro.com

Replacing batteries

Replace the batteries of the thermostat when the low battery
icon appears in the display.
The illustration below shows how to change batteries.
2
Figure 7-6: Replacing batteries
1. Angle the thermostat from the bracket.
2. Remove it from the wall.
3. Replace the batteries.

Factory reset

Factory reset sets all parameter values to default settings.
Important! Do not factory reset the thermostat
if not absolutely needed.
Important! A factory reset removes the
registration data from the thermostat.
1. Press and hold the –, + and OK buttons for about 5 seconds
until the screen goes blank.
2. The thermostat is now reset to factory default.
3
1