Quick Guide; Thermostat Operating Instruction - Uponor Smatrix Move PLUS Quick Manual

Quick Guide

N O T E !
This is a quick start guide to serve as a
reminder for experienced installers. We
strongly recommend reading the full
installation and operation manual before
installing the control system.
PUMP P1
230 V 50 Hz
L
230 V 50 Hz
*) The outdoor temperature sensor can be connected to either the controller or to a thermostat.
**) Connect either COLD or PUMP P2 (secondary heating/cooling circuit) to the connection terminal.
***) Select one of the inputs (heating/cooling switch, pump control signal, or immersion thermostat) and set parameter 11 – Wired Input 1 selection, or parameter 12 – Wired
Input 2 Selection, accordingly. The heating/cooling option can only be used in systems without a registered wireless thermostat.
****) Optional temperature limiter connection, fi tted with a cable bridgre from the factory. Remove the bridge if a temperature limiter is to be used together with PUMP P1.
*****) Optional return sensor. Can only be used, for boost function, in systems without a registered wireless thermostat.

Thermostat operating instruction

T-168
T-167
T-166
U P O N O R S M AT R I X M O V E P L U S · Q U I C K G U I D E
Q U I C K G U I D E
ACTUATOR 230 V
POWER
230 V AC
50 Hz
N
N L
230 V 50 Hz
230 V 50 Hz
L 2
4
N
In2
L
In1
N
In1
PUMP P2 **
CONTACT
Ther ****
T-163
20
5 35
Warning!
Electrical installation and service behind
secured 230 V AC covers must be carried
out under the supervision of a qualifi ed
electrician.
SENSORS
OUTSIDE *
WATER RETURN *****
WATER IN
In1/In2 *** In1/In2 ***
In2
UK
CZ
DE
DK
EE
ES
FI
FR
HR
HU
IT
In1/In2 **
LT
LV
NL
NO
PL
PT
RO
RU
SE
SK
7