Overview; Safety Symbols; Safety Measures; Power - Uponor Climate Control Zoning System II Installation And Operation Manual

Overview

Uponor strongly recommends reading this entire installation
and operation manual before installing the control system .

Safety symbols

The following symbols are used in this document to indicate
special precautions when installing and operating any
Uponor equipment .
Warning! Ignoring warnings can cause injury or
damage to components .
Caution: Ignoring cautions can cause
equipment malfunctions .

Safety measures

Conform to the following measures when installing and
operating any Uponor equipment .
• Read and follow all instructions in this document .
• Ensure a trained installer performs all work in accordance
with local regulations .
• Do not make changes or modifications not specified
in this document .
• Switch off all power supply before starting any wiring work .
• Do not use water to clean Uponor components .
• Do not expose Uponor components to flammable
vapors or gases .
Uponor cannot accept any responsibility for damage or
breakdown that can result from ignoring these instructions .

Power

Warning! The Uponor system uses 24 VAC, 60 Hz
power . In case of emergency, immediately disconnect
the power .

Technical constraints

Caution: To avoid interference, keep installation/data
cables away from power cables of more than 50 VAC .

Limitations for radio transmission

The Uponor Climate Control Zoning System II uses radio
transmission . The frequency used is reserved for similar
applications, and the chances of interference from other radio
sources are very low .
However, in some rare cases, it might not be possible to
establish perfect radio communication . The transmission
range is sufficient for most applications, but each building has
different obstacles affecting radio communication and maximum
transmission distance. If communication difficulties exist, Uponor
recommends relocating the antenna to a more optimal position
and ensuring radio sources are at least 16" (40 cm) apart for
solving exceptional problems .
iv | uponorpro .com

Compliance

This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received,
including interference that may cause undesired operation.
Note: The grantee is not responsible for any changes or
modifications not expressly approved by the party responsible
for compliance. Such modifications could void the user's
authority to operate the equipment.
This device complies with Industry Canada licence-exempt RSS
standard(s). Operation is subject to the following two conditions:
(1) This device may not cause interference, and
(2) This device must accept any interference, including
interference that may cause undesired operation of
the device.
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Proper disposal of waste electrical and
electronic equipment
This marking shown on the product or its literature
indicates it should not be disposed with other household
waste at the end of its working life . To prevent possible harm
to the environment or human health from uncontrolled waste
disposal, please separate this form from other types of wastes
and recycle it responsibly to promote the sustainable reuse of
material resources .
Contact your installer or local government office for details
about environmentally safe recycling .