Registering Thermostats In The Base Unit - Uponor Climate Control Zoning System II Installation And Operation Manual

Registering thermostats in the base unit

1. Press and hold the OK button on the controller until the LED
for channel 1 (or the first unregistered channel) flashes red.
2. Use buttons < or > to move the pointer (LED flashes red)
to a preferred channel.
3. Press the OK button to select the channel for registration.
The LED for the selected channel starts flashing green.
4. Repeat steps 2 and 3 until all channels to be registered
with the thermostat are selected (LEDs flashing green).
Note: Uponor recommends registering all channels to the
thermostat at the same time.
5. Select a thermostat.
Wireless Dial Thermostat (T-165) (A3800165)
Gently press and hold the registration button on the
thermostat, release when the LED on the front of the
thermostat starts flashing. The selected channel LED in the
controller turns fixed green and the registration is complete.
Wireless Digital Thermostat (T-167) (A3800167)
Press and hold both - and + buttons on the thermostat until
the text CnF (configure) and a communication icon is
displayed. The selected channel LED in the controller turns
fixed green and the registration is complete.
6. Repeat steps 2 through 5 until all used room thermostats
are registered.
7. Press and hold the OK button on the controller until the green
LEDs turn off to end registration and return to run mode.
18 | uponorpro.com
1 2
3 4
5
A3800167
6 7
2
5
Figure 4-12: Registering thermostats
2
3
A3800165